The Clearvision is a polycarbonate and aluminium roller shutter which enables clear through-vision and flow of light whilst providing security and protection from the elements and dust.
This shutter can be controlled manually or electronically. Manual operation is push up or pull down, assisted by springs, and lockable with a key. Motorised shutters can be operated with either key switch or remote control.Single Clearvision shutters can be manufactured up to a width of 3.6M or a total of 9 square metres.Clear anodised is the standard, whilst Dulux powder coat range is available as an optional extra.
Why should I choose the Clearvision Shutter for my Business?
The combination of polycarbonate and aluminium means the door allows outsiders to see in, while retaining its security properties through its extruded aluminium joining sections.
Suitable for most commercial applications including: Shopping centre shopfronts, counter and bar tops, food service areas, entrances and doorways, retail stores, shopping arcades, clubs, reception areas. A 12 month warranty against defective materials and workmanship applies.
Curtain – The curtain is constructed of clear polycarbonate extruded slats with a viewing coverage of 95mm. These are interlocked with aluminium extruded joining sections with coverage of 29mm forming a continuous hinge. The ends of these aluminium sections are fitted with a nylon end clip. The curtain may also be in filled with solid aluminium slats if no vision is required.
Bottom Rail – The bottom rail is manufactured from an extruded aluminium section 90mm in height and 20mm in width. The locking mechanism for the shutter is concealed in this rail and can be key-operated from both sides.
Locking – Locking is a two way key mortice lock mounted in the centre of the bottom rail that slides a steel shoot bolt out into the side guides. Standard locking position allows for double-sided locking with operation from both inside and out. Multiple doors can also be keyed alike.
Side Guides – Side Guides are 50mm deep by 32mm wide extruded aluminium suitable for face fit or through the mouth of the guide if fitted between walls.
Mullions – The standard 180 degree mullion is manufactured from an extruded aluminium section 130mm wide x 32mm; a steel shoot bolt secures the mullion into the floor. Special mullions are also available to suit a variety of degrees and applications. Special wide mullions can be manufactured to suit and angle shall be fabricated with 1.6mm aluminium sheet securely fitted to our standard side guides for angle openings where doors need to be stacked.
Brackets – Brackets are manufactured from slotted 90mm x 40mm mild steel.
Drum – The drum is manufactured using either a 229mm or 150mm diameter spiral ducted tube with mild steel wheels and fully enclosed high grade bearings that rotate around a 33mm steel shaft. A helical coil spring designed to counterbalance the curtain weight is fitted to the shaft.
Note: Technical specifications may change without notice, always consult your Security365 representative.